![]() Then take the brush by the handle, holding it below belt level, and use your wrist to flick the release onto the surface in a light, uniform layer. Dip the brush into the pail of release and fluff it to load the bristles and coat them evenly. The best way to apply a powdered release is with a dry tampico brush about 8 inches wide. Apply release agent Powdered or liquid release agents serve two important purposes: They impart subtle color contrast while acting as a bond breaker to prevent the stamping mats or skins from sticking to the concrete and disturbing the imprint texture. Avoid too much buildup, which could interfere with the imprint texture, especially lighter textures.Ģ. Right before you stamp, apply a powdered release with a dry tampico brush in a flicking motion. Here, Bob Harris, author of Bob Harris' Guide to Stamped Concrete, offers this step-by-step overview of the stamping process along with tips for achieving the best results. If you're a homeowner thinking about stamping your own concrete, read this: DIY Stamped Concrete - Why It's Better Left to the Pros.įind contractors specializing in stamped concrete near me. For large projects in particular, that means diagraming the stamping layout in advance, having the stamping tools lined up and ready to go, and making sure enough labor is available for the job at hand. To do the job successfully, contractors must be experienced, organized, and well prepared. Unlike when applying a decorative coating or stain to hardened concrete, crews need to complete the entire stamping process before the fresh concrete sets. There are a lot of steps involved in stamping concrete, and only a short window of time in which to get them done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |